This system works with the highest technology, It has easy-to-use software with a large number of tools for visualization and analysis of tests. The system allow to add modules so the number of data channels can be expanded to add accessory sensors as much as desired. Communication is done through fiber optics avoiding all kinds of electrical noise problems, which is very important in a dynamometer environment, usually susceptible to this phenomenon.
Acquisition software displays the power and torque curves in real time as the test is performed. Results can be viewed on flexible charts where all measured parameters and the number of different tests required can be compared. It is also possible to build comparative tables and reports of measurements.
Auxiliar Sensors:
- Weather Station: reads temperature, humidity and atmosphere pressure in the test room. The system calculates and applies in real time the power correction factor calculated with these readings.
- Water/Oil Temperature
- Exhaust Temperature
- Oil Pressure
- Fuel Pressure
- Lambda sensor
- Air consumption measurement
- Fuel consumption measurement
- Blow by sensor
- Knock sensor
Automatic Control
The system can be adapted to any water brake dyno. Allows automatic tests, ensuring excellent repeatability, very comfortable and easy operation and eliminating the "operator error". The control sets the brake load to adjust the engine RPM automatically and according to the configured RPM limits and test length, it runs a test only by pushing a button.
It includes an electronically operated valve that avoids going through the command console with the water pipes. The valve can also be commanded with a knob to work manually in the traditional way.
